Digistat scr manual override

MANUAL OVERRIDE The heating can be manually switched on and off by using the ‘OVERRIDE’ button on the SCR in a fault situation, even though the red LED will stay on until a satisfactory signal is reinstated. Once the SCR receives a satisfactory signal again, it will automatically reset itself for normal operation. Digistat RF 1 ‘Wireless.  · Put the SCR unit into its manual override mode by pressing the override button No.2 once. Check the green light comes on and that the boiler fires (Do not press again). I have a Drayton Digistat SCR with a remote digitial temperature control. Digistat RF1 Digistat RF2 Digistat RF3 Digistat RF3i Data Sheet: S03 For additional information on fault finding on the SCR unit please see data sheet S SCR Fault Finding Flow Chart The unit is now working correctly Call heating engineer Yes Proceed from data sheet S Drayton RF Digistat SCR Fault Finding Flow Chart.

Put the SCR unit into its manual override mode by pressing the override button No.2 once. Check the green light comes on and that the boiler fires (Do not press again). I have a Drayton Digistat SCR with a remote digitial temperature control. The heating can be manually switched on and off by using the ‘OVERRIDE’ button on the SCR in a fault situation, even though the red LED will stay on until a satisfactory signal is reinstated. achieved by commissioning each Digistat and SCR in turn. 1. Install (see installation instructions) and turn power on to the SCR (receiver). If a separate programmer is fitted, ensure that it is switched on. The red LED should come on. 2. Push the ‘override’ button on the SCR once. The green LED should also come on.

MANUAL OVERRIDE. The heating can be manually switched on and off by using the 'OVERRIDE'. button on the SCR in a fault situation, even though the red LED. Drayton. Digistat +RF. Room Thermostat Wireless. Models: RF To check the SCR is wired correctly, press the override button No.2 once and. To do this: press button 1 and then button 2 (override) and hold together for a couple of seconds. Let go and the red light should flash for 7 seconds. The red.